Redline Communications RDL-2000 Bedienungsanleitung PDF herunterladen (Seite 44)

RDL-2000 User Manual

5 CLI Interface

This section describes the RDL-2000 operations available when using the Command

Link Interface (CLI) over a Telnet Connection. All commands are ca se-sensitive. The

user is not required to login for basic access.

Note: The CLI does not support all features necessary to configure and operate the RD-

2000. Use the Link Manager applications to deploy and monitor the RDL-2000 units.

The following table contains a summary of available CLI commands.

Table 8: CLI -Command Summary

Master

Slave

Command

Description

√

aes

Activate/deactivate AES (encryption)

√ √

atpc

Set ATPC mode and power level

√

autorate

Activate/deactivate auto rates

√

extsync

Set/show ext/GPS sync (not supported in this release)

√ √

firmware

Upgrade firmware

√ √

help, ?

Show all available commands

√

Set/show id (MAC address format)

√ √

Set/show IP

√ √

logger

Activate/deactivate Ethernet logger

√

mgmtvid

Set/show Mgmt VLAN tag

√ √

power

Set/show tx power

√ √

pwd

Set password

√ √

quit

Exit shell

√

rate

Set/show peer downlink/uplink rates

√ √

reset

Reset unit and exit shell

√ √

rssi

Activate/deactivate RSSI collection

√ √

rtext

Show last reset text

√

set

Set/show link peer with this MAC address

√ √

sweep

Perform spectrum sweep

√ √

switchbank

Switch firmware banks and reset

√

update

Program non volatile flash with parameter changes

√ √

[user pass]

Chapter 5

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare

Redline Communications RDL-2000 Bedienungsanleitung Seite 44

Kommentare zu diesen Handbüchern