Redline Communications RDL-2000 Bedienungsanleitung PDF herunterladen (Seite 41)

RDL-2000 User Manual

Drop Counter (Packets): Number of ARQ timeouts.

Air Counter (Bytes): Total number of bytes transmitted over the wireless interface.

Air Counter (Packets): Total number of packets transmitted over the wireless interface.

Tx Throughput (Mbps): Current transmitted throughput.

Statistics for the receiver section of the air interface.

Air Counter (Bytes): Total number of bytes received.

Air Counter (Packets): Total number of packets received.

Air CRC Counter (Packets): Total number of packets received with CRC errors.

Rx Throughput (Mbps): Current received throughput.

Tx Power Control

Use these settings to manually adjust the output characteristics of the RDL-2000.

Note: These manual settings override automatic system adjustments for modulation

settings and may result in over-the-air errors. Changes are not saved permanently and

the saved configuration is restored on the next system reboot.

Tx Power (tx pwr table): Use this control to manually adjust the Tx power setting. Changes

made using these controls are sent to the RDL-2000 by clicking the Submit button.

RF Attenuator (0-31): Use this setting to attenuate the signal. Changes made using the

up/down controls are sent immediately to the RDL-2000. Values entered in this field are sent

to the RDL-2000 by clicking the Submit button.

Tx Power Reg (0x00-0xff): Changes made using the up/down controls are sent

immediately to the RDL-2000.

Get Config: Click this button to load the saved Tx power settings from the RDL-2000.

Submit: Click this button to send the RF Attenuator and Tx Power Reg settings to the

RDL-2000. Changes made in this screen are not saved in the RDL-2000.

Utility Variables

These settings are for factory test only.

Reset Logger

This control is for factory test only.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 50 51

Keine Kommentare

Redline Communications RDL-2000 Bedienungsanleitung Seite 41