Redline Communications RDL-2000 Wartungshandbuch PDF herunterladen (Seite 44)

RDL-2000 Installation Guidelines

4.5.10 Configure PTP Master

The following instructions must be performed in the order listed. The configuration listed

here is to facilitate installation only. Refer to your detailed RF plan for any other required

parameter settings.

1. Start the Link Manager (Start-> Link_Manager-> Link_Manager), click 'E' on

the toolbar to start a session and login as Admin.

2. Display the License screen and Drag & Drop the licence file for this MAC

address onto the license screen. Click Submit to activate the license. The

RDL-2000 will automatically reboot.

Important: Exit from the Link Manager after changing the license file, and

then re-start the Link manager application to load the new RDL-2000 settings.

3. PTP Master Link Configuration Screen

a. Channel BW: This must match the slave unit (RF plan).

b. Enable MIMO:

(Enabled)

c. Unit Type = PTP Master

Important: If the unit is currently a PTP Slave, you must click Submit to

reboot the unit in PTP Master mode before continuing the setup.

d. MU ID: Enter SU ID of connected slave unit (RF Plan).

e. SU MAC Address: Enter MAC of connected slave unit.

f. Channel: Select the required RF channel from the list (RF Plan).

g. Enable ACS: (Enabled).

h. Click Submit Parameters (RDL-2000 may automatically reboot)

Figure 32: Link Manager - Master - Link Configuration Screen

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Keine Kommentare

Redline Communications RDL-2000 Wartungshandbuch Seite 44